Mr. Wright Flooring Inc. logo
All posts

Flooring Installation and Care Guide for Jacksonville Homes

What goes under a new floor, how to clean it and how to measure for it, using the rules Mohawk, Pergo, NWFA and CRI publish for each type of floor.

Mr. Wright Flooring · Nov 18, 2026

Installer marking a light plank with a pencil, a mallet on the floor beside him

Installing and caring for a floor the right way comes down to following the instructions written for that exact product: what goes underneath it, how it is cleaned, and how much of it to order. Those rules come from the manufacturer and change from one product line to the next, so Mohawk, Pergo, the National Wood Flooring Association (NWFA) and the Carpet and Rug Institute (CRI) do not always agree.

Mr. Wright Flooring is a family-owned flooring company in Jacksonville, serving Northeast Florida since 2012. We're an authorized Mohawk retailer, an NWFA member and CFI Certified, and we carry Pergo, RevWood, TecWood, SolidTech, PureTech, SmartStrand and EverStrand. This guide sums up what those makers and trade groups publish about underlayment, carpet padding, cleaning, hardwood care, measuring and slab prep, with a link to a deeper article on each. If you are still choosing a floor, start with our Florida flooring guide.

What goes under laminate flooring

Pergo's laminated wood installation instructions settle laminate underlayment with two questions: is the subfloor concrete or wood, and does the flooring already have underlayment attached? Over a wood subfloor, planks with attached underlayment need no extra underlayment or vapor barrier, and planks without it need underlayment added. Over concrete, planks with attached underlayment need a vapor barrier, and planks without it need both underlayment and a vapor barrier. Mohawk's RevWood instructions use the same table.

Pergo's supply list names a 6-mil polyethylene vapor barrier, and Pergo's FAQ says a 6-mil barrier, overlapped at least 8 inches and taped, is required on all concrete installations. Our guide to laminate flooring underlayment walks through each case and where Pergo's FAQ and instructions differ.

Laminate underlayment by subfloor and plank type
PlankWood subfloorConcrete subfloor
Underlayment already attachedNo extra underlayment or vapor barrierVapor barrier
No underlayment attachedUnderlaymentUnderlayment and vapor barrier

Source: Pergo laminated wood installation instructions; Mohawk's RevWood instructions use the same table.

Do vinyl plank floors need underlayment?

Some rigid vinyl planks come with a pad already attached. Mohawk's SolidTech instructions tell installers to cut the plank's foam underlayment after snapping a plank, and Pergo's FAQ says Pergo Extreme rigid vinyl has an attached pad for stability and sound underfoot. For floating SolidTech installs over concrete, Mohawk highly recommends a 6-mil polyethylene vapor barrier, and it says an underlayment will not correct a subfloor that flexes or is uneven. Our vinyl plank flooring underlayment guide covers SolidTech and PureTech and the subfloor work that comes first.

Tools laid out on a white hexagon tile floor

Choosing carpet padding

CRI calls a firm, resilient cushion the foundation of a carpet, and it warns that the wrong cushion can cause wrinkling, buckling and separated seams and may void the carpet maker's warranty. Its general rule for most residential carpet is a cushion 1/4 to 7/16 inch thick at 6 pounds per cubic foot density. Mohawk's carpet warranty sets its own minimum of 5 pounds per cubic foot and 3/8 to 1/2 inch thick, and CRI says to check the carpet manufacturer's requirement first.

Berber carpet needs a thinner, firmer pad under both sources' guidance, and CRI applies the same limit to other low-profile carpet. Our carpet padding guide lays out CRI's and Mohawk's numbers side by side.

Key takeaway

What goes under a floor is set by that product's instructions and warranty, so an underlayment or pad that suits one line can be wrong for another.

How to clean LVP floors

For everyday cleaning, Mohawk's care page for its resilient and vinyl floors says to sweep with a soft-bristle broom and, for a deeper clean, to use a mop moistened with warm water and a non-abrasive, neutral pH cleaner. The details change by product. Mohawk's SolidTech instructions say not to use ammonia, while the instructions for its PureTech resilient flooring allow 1 cup of vinegar or 1/3 cup of non-sudsing ammonia per gallon of water if needed. Our guide on how to clean LVP floors sorts the rules line by line.

Empty room with a dark wood floor

How to clean laminate floors

Mohawk's care page says never to use a vacuum with a beater bar or power rotary brush head on its laminated wood floors. How wet the mop can be depends on the line. Mohawk's wood warranty brochure says RevWood Essentials is damp mop only and not designed for wet or steam mopping, while RevWood Plus and Premier carry Mohawk's WetProtect warranty, which covers steam, wet or damp mopping, though not damage at an unsealed perimeter. Pergo's laminate care page suggests a damp mop with 1 cup of household vinegar or 1/3 cup of ammonia in a gallon of warm water. Our guide on how to clean laminate floors covers both brands.

Caring for hardwood floors

The NWFA's installation guidelines say to dry sweep wood floors daily with a good dusting mop and to damp mop weekly with a mop that is well wrung out, leaving very little moisture on the floor. NWFA also says not to use vinegar or steam cleaners on wood floors. Mohawk's rules for its own products can differ: its care page allows a vinegar solution on its wood floors where the product's wet warranty permits mopping, and Mohawk's TecWood Enhanced warranty says that floor will withstand steam, wet or damp mopping. NWFA itself says to follow the flooring or finish manufacturer's recommendations.

Humidity is part of hardwood care too. NWFA recommends a consistent indoor environment year-round, with a dehumidifier in humid months, and Mohawk's TecWood instructions call for 35% to 55% relative humidity for the life of the floor. Our hardwood floor care guide covers everyday cleaning, protection and humidity.

Key takeaway

Know the exact line and sub-line of your floor before you clean it, because Mohawk, Pergo and NWFA give different answers on vinegar, ammonia and steam.

How to measure for flooring

Measuring starts with square footage. Pergo's DIY installation steps begin with measuring and calculating square feet, and NWFA notes that most wood flooring is packaged by the square foot, while baseboards, transitions and borders are usually ordered by the lineal foot. Carpet works differently. Mohawk says carpet comes in 12- and 15-foot widths seamed in the same direction, and that 15% or 20% waste on a job is not unusual, depending on the room and where the seams fall.

Mohawk's PureTech warranty brochure also recommends keeping leftover planks from your installation for your warranty and for future repairs. Our guide on how to measure for flooring explains how to measure your rooms before you shop.

Before installation: acclimation and the slab

Two more rules appear in the Mohawk and Pergo instructions cited here: acclimation and subfloor moisture. Mohawk says its wood floors must acclimate at least 72 hours, after the HVAC, windows and building envelope are complete and running, and its SolidTech vinyl calls for 48 hours in the room of installation. Pergo's laminated wood instructions need no on-site acclimation if the flooring arrives at the home's normal living conditions and those conditions are kept, and 48 hours otherwise.

Each line also sets its own limit for a concrete slab. Pergo's laminated wood allows up to 5 pounds per 1,000 square feet per 24 hours on a calcium chloride test, or 80% relative humidity or less with an in-slab probe. Mohawk's SolidTech allows up to 8 pounds, or less than 90%. Mohawk's SolidTech instructions put the final call on whether the concrete is dry enough with the floor covering installer. Our post on glue-down vs. floating floors over concrete covers slab installs in more depth.

Key takeaway

Acclimation times and slab moisture limits belong to the product, so the installer should confirm both against that line's instructions before the first plank goes down.

Acclimation and concrete slab limits, by product line
Product lineAcclimationCalcium chloride testIn-slab probe
Pergo laminated woodNone if it arrives at the home's normal living conditions and they are kept; 48 hours otherwiseUp to 5 lb per 1,000 sq ft per 24 hours80% relative humidity or less
Mohawk SolidTech48 hours in the room of installationUp to 8 lbLess than 90%

Sources: Pergo laminated wood installation instructions; Mohawk SolidTech installation instructions. Mohawk's SolidTech instructions put the final call on slab dryness with the floor covering installer.

Getting help with your floor

You can buy flooring from us and have our crew install it, have us install flooring you bought elsewhere through our professional installation service, or buy the material from us and install it yourself or hire your own crew. On every project we install, an experienced team leader supervises the work and keeps it inside the manufacturer's warranty guidelines.

When you supply the material and we install it, our warranty is 1 year on material and 1 year on labor from the installation date. When we supply both the material and the installation, it is 2 years on material and 2 years on labor. Request a free estimate and we will measure your rooms at no charge, or call (904) 443-9473 to set an appointment to browse the selections in our showroom.

Frequently asked questions

Do I need underlayment under laminate flooring?

It depends on your subfloor and your planks. Pergo's laminated wood instructions say planks with underlayment already attached need nothing more over a wood subfloor and a vapor barrier over concrete. Planks without attached underlayment need underlayment added over wood, and underlayment plus a vapor barrier over concrete, which can be an underlayment with a built-in moisture barrier. Mohawk's RevWood instructions use the same table. Pergo's FAQ adds that a 6-mil polyethylene moisture barrier is required on all concrete installations.

Does vinyl plank flooring need underlayment?

Some rigid vinyl planks have one attached. Mohawk's SolidTech planks carry a foam underlayment, and Pergo says its Pergo Extreme rigid vinyl has an attached pad. Mohawk's SolidTech instructions do not say whether a separate pad may be added under that foam, so ask before adding one. For floating SolidTech installs over concrete, Mohawk highly recommends a 6-mil polyethylene vapor barrier, and it says the barrier is not a fix for moisture problems.

How thick should carpet padding be?

Check the carpet manufacturer's requirement first, as CRI advises. CRI's general rule for most residential carpet is a cushion 1/4 to 7/16 inch thick at 6 pounds per cubic foot, and no more than 3/8 inch at 8 pounds for berber or low-profile carpet. Mohawk's carpet warranty requires at least 5 pounds per cubic foot and 3/8 to 1/2 inch thick, and for berber-style carpet Mohawk recommends at least 8 pounds and 1/4 to 3/8 inch.

Can I clean my floors with vinegar?

It depends on the floor. NWFA's installation guidelines say not to use vinegar on wood floor finishes, because it is acidic and degrades the finish. Pergo's laminate care page and Mohawk's care page for its wood and laminated wood floors allow 1 cup of vinegar per gallon of water where the product permits mopping, and Mohawk's PureTech instructions allow the same solution if needed. Follow the care instructions for your exact product.

Can I use a steam mop on my floors?

Only if your floor's maker allows it. NWFA says not to use steam cleaners on wood floors. Mohawk says its RevWood Plus floors may be maintained with residential steam mops for the life of the product, while RevWood Essentials is damp mop only and not designed for steam mopping. Mohawk's PureTech warranty brochure says its WetProtect warranty covers damage from steam mopping, with the mop on the lowest appropriate setting and run along the length of the planks. It does not cover damage at an unsealed perimeter. Check the warranty for your floor first.

How much extra flooring should I order?

For carpet, Mohawk says 15% or 20% waste on a job is not unusual, because carpet comes in 12- and 15-foot widths and the waste depends on the room's dimensions and where the seams go. For hard floors, order from a measurement of your actual rooms. Mohawk's PureTech warranty brochure also recommends keeping leftover planks for your warranty and for future repairs. We offer free estimates that include an in-home measure.

Thinking about new floors?

The same crew, still family-owned. Free in-home estimate across Jacksonville and Northeast Florida.